Crochet Bear Puffy Rattle Amigurumi Free Pattern

 Introducing the Crochet Bear Puffy Rattle Amigurumi, a delightful and charming toy that will captivate both children and adults alike. This adorable creation combines the art of crochet with the whimsical world of amigurumi, resulting in a cuddly bear that doubles as a playful rattle. Crafted with love and attention to detail, this crochet bear is sure to become a cherished companion for little ones. This crochet bear is not only a toy but also a work of art. The intricate crochet stitches bring the bear to life, with carefully embroidered eyes and nose that give it a lifelike expression. Its small size makes it perfect for little hands to grasp and hold, promoting fine motor skills development. Whether it's used as a comforting companion during naptime or as a source of entertainment during playtime, the Crochet Bear Puffy Rattle Amigurumi is a timeless treasure that will bring joy and smiles to all who encounter it. 

Materials:

cotton or cotton/acrylic yarn (Alize Cotton Gold, YarnArt Jeans, Vita Lira, etc.);
• eyes for toys (safe – with fastening from the inside of the part);
• sintepuh or other suitable stuffing material;
• wooden ring with an outer diameter of 55 mm;
• rattle (a container with beads or special fittings).
• hook number 2mm
• scissors
• tweezers or stuffing clip
• needle

Abbreviations

Ch: Chain
Sc: Single crochet
Slst: Slip stitch
Dec: Decrease
Inc: Increase
MR: Magic ring

Ring binding:
Dial about 13 ch on the thread. Try on the ring. The binding should not be too tight so that you can turn the ring under it, but it should not hang out either. We close the chain in a ring around the wooden base and start crochet in a spiral single crochets until we tie the entire base. Turn as you knit knitting around the warp. When you come to the end, align the entire canvas and sew the ends strapping. Tie the thread in a knot and hide in the canvas.

Clutch:
Make ch on the threads again, this time about 16 (try on a tied ring).
Lock into a ring and make a lifting loop. This detail must be crocheted using slst and ch in every row. We crochet 18 rows in this way. At the end of the last row, change the color of the thread. on the other, we fill the ponytails into columns. We knit the last slst, pull the thread and
we restore the edge of the part (cut the thread of sufficient length), then we fill it under columns from the wrong side. We attach the thread of the same color to the other side muffs and also tie and decorate it. There should be 20 rows in total. We unfold the sleeve with the seam down, on the inside of the ring.

Handles

2 parts in a spiral without ch and slst.
Rnd 1. 2 ch, 6 sc in the first loop (6) or MR
Rnd 2. 6 inc (12)
Rnd 3. (1,inc)*6 (18)
Rnd 4. 1,inc, (2,inc)*5,1 (24)
Rnd 5-6. 2 rows (24)
Rnd 7. (2,dec)*6 (18)
Rnd 8-9. 2 rows (18)
Rnd 10. (1,dec)*6 (12)
Rnd 11. (dec)*6 (6)

Fold in half and connect the halves with 3 sc, knot, cut a long thread for sewing. We sew the handles to the seventh row of the clutch on each side, the thread tie a knot and hide.

Head